Exponential Stability for Time-changed Stochastic Differential Equations

Acta Mathematicae Applicatae Sinica, English Series - So far there have been few results presented on the exponential stability for time-changed stochastic differential equations. The main aim of...     

Preparation and Properties of Sr3B2O6:Dy3+, Eu3+ White Phosphors Using the High-Temperature Solid-State Method

Journal of Applied Spectroscopy - Sr3B2O6:Dy3+, Eu3+ single-matrix white-light-emitting materials are prepared using the high-temperature solid-state method. The microstructure, emission spectrum,...     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

Manage Pension Deficit with Heterogeneous Insurance

This paper considers a positive and increasing pension deficit of a certain pay-as-you-go (PAYG) pension system, and tries to make up for this deficit by using heterogeneous insurance. The positive pension deficit is formulated as a mathematical function in continuous time. The surplus of an appropriate heterogeneous insurance is described by diffusion approximation of a Cramér-Lundberg process. The system of extended Hamilton-Jacobi-Bellman equations under mean-variance criterion is established. The closed-form solution and optimal surplus-multiplier of heterogenous insurance are obtained. Some interpretations further explain the theoretical values of the results.

     

Enhanced Power Density of Alcohol Biofuel Cell by Polymer-assisted Crosslinks of 3D Graphene on Carbon Paper as the Bioanode

Herein, we successfully construct the 3D biocompatible graphene through crosslinking 2D graphene nanosheet onto carbon fiber paper with poly(diallyldimethylammonium chloride) (PDDA) as anode of the alcohol biofuel cell. Compared with the bioanode without 3D graphene, the current density and output power of PDDA-graphene-ADH bioanode is increased by 23 % and 41 % at a high concentration of ethanol at pH 8.9, suggesting the stabilization role of graphene in enzyme loading. The study provides us a deep analysis on structures and performances of the bioanode incl. electrochemistry, X-ray photoelectron spectra, and atomic force microscopy images, which is significant to develop the new methods to construct 3D porous electrodes in energy conversion device.     

复合电极La-Ni-B的制备及电催化偏硼酸钠的性能

为进一步提高对偏硼酸钠电催化还原的效率,采用化学镀的方法,以铜片为基体,PdCl2乙醇胶体溶液为活化剂,乙醇为化学镀溶剂,制备了稀土复合电极La-Ni-B.并采用XRD、SEM、EDS方法对催化剂进行表征分析,结果表明稀土合金以纳米颗粒的形式附着在基体表面,所得合金膜是非晶态的.通过循环伏安法研究了复合电极La-Ni-B用于电解偏硼酸钠制备硼氢化钠的可行性.以硼氢化钠实际生产量为指标,探讨了直流、脉冲两种不同供电方式、脉冲电流频率、电解时间对电解行为的影响.结果表明稀土镧对电解偏硼酸钠有催化作用,以20 mL镀液制备的复合电极,在脉冲频率阳极时间T1=1 s,阴极时间T2=1 s时,最佳电解时间为4h.复合电极在重复使用3次的情况下,硼氢化钠产量降低15;,催化剂的重复使用性能良好.     

Nickel (II) tetrapyridyl complexes as electrocatalysts and precatalysts for water oxidation

Two nickel complexes, [Ni(tpen)](ClO₄)₂.0.5CH₃COCH₃ ( 1 ) and [Ni(tpbn)](ClO₄)₂ ( 2 ), of tetrapyridyl ligands N,N,N′,N′-tetrakis(2-pyridyl-methyl)-1,2-ethanediamine (tpen) and N,N,N′,N′-tetrakis(2-pyridyl-methyl)-1,4-butanediamine (tpbn) were prepared and their catalysis for water oxidation reaction (WOR) studied. In 0.1 M phosphate buffer solution (PBS) of pH 8.0, complex 1 is a homogeneous molecular catalyst with an overpotential of ~440 mV and a Faradaic efficiency of 89%. At pH ≥ 9.0, complex 1 degraded gradually during the catalytic process and formed NiO_x composite (nickel oxide with general formula Ni_xO_yH_z) active for WOR. In contrast, complex 2 deteriorated under measured conditions (pH 8.0–12.0) and formed NiO_x composite active for WOR. The NiO_x composite derived from 1 in 0.1 M PBS at pH 11.0 showed an activity with an overpotential of ~500 mV, a Tafel slope of ~90 mV/decade and a Faradaic efficiency of 97%. Mechanisms were proposed for water oxidation catalyzed by 1 and 2 . This work revealed that the catalytic activity of the nickel complexes was related to the flexibility of the tetrapyridyl ligands and the adaptability of the coordination sphere of the nickel(II) center.     

四方体MgO的制备及对有机染料的吸附

以六水氯化镁和六次甲基四胺为原料,采用水热法合成四方体MgO,考察其对有机染料甲基橙和亚甲基蓝的吸附行为.通过TGA-DTA、SEM、XRD、N2-sorption和FT-IR等手段表征样品.结果表明,原料浓度、温度和表面活性剂对四方体MgO结构的形成影响较小,而反应时间的延长有助于有序结构的组装.温度170℃、时间24h、MgCl2·6H2O与C6H12N4浓度比为1∶2和表面活性剂PVP是制备四方体MgO的最佳条件.在溶液浓度10mg · L-1的单一吸附实验过程中,四方体MgO对甲基橙和亚甲基蓝的去除率分别为91.3;和22.3;,吸附过程均为单层吸附且符合Langmuir等温吸附模型和伪二级吸附动力学方程.在溶液浓度40 mg·L-1、甲基橙和亚甲基蓝浓度比3∶1的混合溶液吸附过程中,四方体MgO对甲基橙和亚甲基蓝的去除率分别为80.1;和97.9;.     

Development of an ultra-performance liquid chromatography-electrospray ionization-Orbitrap mass spectrometry method for determination of xanthopurpurin in rat plasma and its application to pharmacokinetic study

A rapid and sensitive method was developed and validated for the quantitative determination of xanthopurpurin (XPP) in rat plasma using ultra-performance liquid chromatography-electrospray ionization-Orbitrap mass spectrometry. XPP inhibits IgE production and prevents peanut-induced anaphylaxis. The XPP and emodin (internal standard) were determined in negative ion mode with m/z 239.0350 → 211.0400 and 269.0455 → 241.0507, respectively. The separation process was achieved using an ACQUITY UPLC HSS T₃ column with acetonitrile and 0.1% formic acid in water (85:15). The linear range was 0.5–100 ng/mL, and the correlation coefficient (r²) was > 0.993. The inter-day and intra-day precision was within an acceptable range of 15%. The extraction recovery and matrix effect were 78.9–87.2% and 94.3–98.5%, respectively. Under different conditions, the XPP was stable in the range of 5.6–10.6%. This method was successfully applied to study the pharmacokinetics of XPP with an oral dose of 10.0 mg/kg and intravenous dose of 2.0 mg/kg in rats. The absolute oral bioavailability of XPP was 4.6%.